Write something about yourself. No need to be fancy, just an overview. No Archives Categories. Following the submission of the comprehensive report, each State Party shall in- clude in the reports they subm it to the Committee on the Ri ghts of the Child, in accordance with Article 44 of the Convention, any furthe r information with respect to the implementa- tion of the Protocol.

Isolation and protection isolation transformers Technical description 18.1 Isolation transformers are used for decoupling of electrical circuits in order to reduce the risk of simultaneous touching of grounded part and the part under voltage. Isolation transformers are used to fulfil 'protective decoupling measures', which means they have a double or reinforced insulation between primary and secondary winding. Connected equipment is isolated from network voltage source and must not be grounded.

Isolation transformers are produced in compliance with EN61558-1/ IEC61558-1, EN61558-2-4/IEC61558-2-4. The following values are applied: Input voltage: up to 1.000 V Frequency: up to 400 HZ Output voltage: up to 1.000 V (in idle time or under load) Power: Single-phase transformers: up to 25 kVA Three-phase transformers: up to 40 kVA Isolating transformers must have a special marking so that they could be distinguished from transformers for other purposes. 18.2 Protection isolation transformers are used for supplying of distribution circuits, machines and other equipment up to voltage 50 V AC or 120 V DC (voltage from rectifier) in idle time or under burden in order to prevent dangerous touch voltages in case of equipment fault. Protective isolation transformers fulfil protective measures 'protection by extra low voltage', which means that they have a voltage of up to 50 V AC on the secondary and double or reinforced insulation between the primary and secondary winding. Also, they are used where the usual protective measures may not be applied, such as e.g. TN protection system against touch voltage.

They are produced pursuant to EN61558-1/ IEC61558-1, EN61558-2-6/IEC61558-2-6, EN61558-2-13/IEC61558-2-13. The following values are applied: Input voltage: up to 1.000 V Frequency: up to 400 HZ Output voltage: up to 50 V (in idle time or under load) Power: Single-phase transformers: up to 10 kVA Three-phase transformers: up to 16 kVA Protective isolating transformers must have a special marking so that they could be distinguished from transformers for other purposes.

• Spravato (esketamine) is a rapid acting, nasal spray formulation of a non-competitive N-methyl D-aspartate. • Jeuveau (prabotulinumtoxinA) is a botulinum toxin type A formulation for the temporary improvement in the. • Ultomiris (ravulizumab-cwvz) is a long-acting C5 complement inhibitor for the treatment of paroxysmal. • Motegrity (prucalopride) is a selective serotonin type 4 (5‑HT4) receptor agonist for the treatment of c. • Xospata (gilteritinib) is a kinase inhibitor indicated for the treatment of patients who have relapsed.

• Daurismo (glasdegib) is a hedgehog pathway inhibitor indicated for the combination treatment of adult.